Rohde & Schwarz FSW Series - Analysis; Default Chapter; Trace 1;Trace 2;Trace 3;Trace 4;Trace 5;Trace 6; Trace Mode

Analysis
R&S
®
FSW-K7
130User Manual 1173.9240.02 ─ 17
Trace data can also be exported to an ASCII file for further analysis. For details see
chapter 6.2, "Trace / Data Export Configuration", on page 133.
Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6...................................................... 130
Trace Mode.................................................................................................................130
Detector.......................................................................................................................131
Hold.............................................................................................................................131
Average Mode.............................................................................................................131
Average Count............................................................................................................ 132
Predefined Trace Settings - Quick Config...................................................................132
Trace 1/Trace 2/Trace 3/Trace 4 (Softkeys)............................................................... 132
Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the corresponding trace for configuration. The currently selected trace is high-
lighted orange.
Remote command:
Selected via numeric suffix of:TRACe<1...6> commands
Trace Mode
Defines the update mode for subsequent traces.
"Clear Write"
Overwrite mode: the trace is overwritten by each sweep. This is the
default setting.
Trace Settings