Configuration
R&S
®
FSW-K7
121User Manual 1173.9240.02 ─ 17
► To display this dialog box, do one of the following:
● Select the "Demod Settings" button in the Analog Demodulation "Overview"
and select the "Units" tab.
● Select the MEAS CONFIG key and then the "Scale Config" softkey. Then
select the "Units" tab.
Phase Unit (Rad/Deg).................................................................................................121
THD Unit (% / DB).......................................................................................................121
Phase Unit (Rad/Deg)
Sets the phase unit to rad or deg for displaying PM signals.
Remote command:
UNIT:ANGLe on page 266
THD Unit (% / DB)
Sets the unit to percent or DB for the calculation of the THD (in the Result Summary).
Remote command:
UNIT:THD on page 266
5.9 Output Settings
● Output Settings..................................................................................................... 121
● Analog Demodulation Output Settings..................................................................124
5.9.1 Output Settings
The R&S FSW can provide output to special connectors for other devices.
For details on connectors refer to the R&S FSW Getting Started manual, "Front / Rear
Panel View" chapters.
Output Settings
To Next Page
Loading...
