Rohde & Schwarz FSW Series - 5.4 Input and Frontend Settings

Configuration
R&S
®
FSW-K7
55User Manual 1173.9240.02 ─ 17
Preset Channel
Select the "Preset Channel" button in the lower lefthand corner of the "Overview" to
restore all measurement settings in the current channel to their default values.
Note that the PRESET key on the front panel restores the entire instrument to its
default values and thus closes all measurement channels on the R&S FSW (except
for the default Spectrum application channel)!
For details see chapter 5.1, "Default Settings for Analog Demodulation", on page 50.
Remote command:
SYSTem:PRESet:CHANnel[:EXECute] on page 179
Setup Standard
Opens a file selection dialog box to select a predefined setup file. See "Setup Stand-
ard" on page 52.
Specifics for
The measurement channel may contain several windows for different results. Thus, the
settings indicated in the "Overview" and configured in the dialog boxes vary depending
on the selected window.
Select an active window from the "Specifics for" selection list that is displayed in the
"Overview" and in all window-specific configuration dialog boxes.
The "Overview" and dialog boxes are updated to indicate the settings for the selected
window.
5.4 Input and Frontend Settings
The source and characteristics of the input signal to be demodulated are configured in
the "Input and Frontend Settings" dialog box.
For background information on working with power sensors, see the R&S FSW User
Manual.
► To display this dialog box, do one of the following:
● Select the "Input/Frontend" button in the Analog Demodulation "Overview"
● Select the INPUT/OUTPUT key and then the "Input Source Config" softkey.
● Select the INPUT/OUTPUT key and then the "Power Sensor Config" softkey.
● Input Source Settings..............................................................................................55
● Power Sensor..........................................................................................................81
● Amplitude................................................................................................................ 85
● Frequency............................................................................................................... 92
5.4.1 Input Source Settings
The input source determines which data the R&S FSW will analyze.
Input settings can be configured in the "Input" dialog box.
Input and Frontend Settings