Configuration
R&S
®
FSW-K7
52User Manual 1173.9240.02 ─ 17
Digital standard settings are available via the "Digital Standards" softkey in the MEAS
menu or the "Overview".
Setup Standard............................................................................................................. 52
└ Selecting the Storage Location - Drive/ Path/ Files........................................ 52
└ File Name........................................................................................................52
└ Load Standard................................................................................................ 53
└ Save Standard................................................................................................ 53
└ Delete Standard..............................................................................................53
└ Restore Standard Files................................................................................... 53
Setup Standard
Opens a file selection dialog box to select a predefined setup file. The predefined set-
tings are configured in the R&S FSW Analog Demodulation application. This allows for
quick and easy configuration for commonly performed measurements.
Selecting the Storage Location - Drive/ Path/ Files ← Setup Standard
Select the storage location of the settings file on the instrument or an external drive.
The "Drive" indicates the internal (C:) or any connected external drives (e.g. a USB
storage device).
The "Path" contains the drive and the complete file path to the currently selected
folder.
The "Files" list contains all subfolders and files of the currently selected path.
The default storage location for the settings files is: C:/FSW/user/predefined/
AdemodPredefined.
Note: Saving instrument settings in secure user mode.
In secure user mode all data is stored to volatile memory, and is only available during
the current instrument session. As soon as the power is switched off on the R&S FSW,
the data is cleared.
To store settings permanently, select an external storage location, such as a USB
memory device.
For details see "Protecting Data Using the Secure User Mode" in the "Data Manage-
ment" section of the R&S FSW User Manual.
File Name ← Setup Standard
Contain the name of the data file without the path or extension.
For details on the file name and location see the "Data Management" topic in the
R&S FSW User Manual.
Note: Secure user mode. In secure user mode, settings that are to be stored on the
instrument are stored to volatile memory. To store data permanently, select an external
storage location such as a USB memory device.
For details see "Protecting Data Using the Secure User Mode" in the "Data Manage-
ment" section of the R&S FSW User Manual.
Configuration According to Digital Standards
To Next Page
Loading...
