Rohde & Schwarz FSW Series - 11 Remote Commands for Analog Demodulation Measurements

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
170User Manual 1173.9240.02 ─ 17
11 Remote Commands for Analog Demodula-
tion Measurements
The commands required to perform measurements in the Analog Demodulation appli-
cation in a remote environment are described here.
It is assumed that the R&S FSW has already been set up for remote control in a net-
work as described in the R&S FSW User Manual.
A programming example at the end of the remote commands description demonstrates
the most important commands in a typical application scenario, see chapter 11.11,
"Programming Example", on page 342.
Status registers
The R&S FSW-K7 option uses the status registers of the base unit (except for the
STATus:QUEStionable:ACPLimit register).
For a description see the R&S FSW User Manual.
General R&S FSW Remote Commands
The application-independant remote commands for general tasks on the R&S FSW are
also available for Analog Demodulation measurements and are described in the
R&S FSW User Manual. In particular, this comprises the following functionality:
●
Managing Settings and Results
●
Setting Up the Instrument
●
Using the Status Register
Channel-specific commands
Apart from a few general commands on the R&S FSW, most commands refer to the
currently active channel. Thus, always remember to activate an Analog Demodulation
channel before starting a remote program for an Analog Demodulation measurement.
● Introduction........................................................................................................... 171
● Common Suffixes..................................................................................................175
● Activating Analog Demodulation Measurements.................................................. 176
● Configuring the Measurement...............................................................................180
● Capturing Data and Performing Sweeps...............................................................277
● Configuring the Result Display..............................................................................282
● Retrieving Results.................................................................................................289
● Analyzing Results..................................................................................................299
● Importing and Exporting I/Q Data and Results......................................................340
● Commands for Compatibility.................................................................................341
● Programming Example..........................................................................................342