Rohde & Schwarz FSW Series - 6.8 Zoom Functions

Analysis
R&S
®
FSW-K7
153User Manual 1173.9240.02 ─ 17
Insert Value
Inserts a data point in the limit line above the selected one in the "Edit Limit Line" dia-
log box.
Delete Value
Deletes the selected data point in the "Edit Limit Line" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width (as opposed
to an additive offset defined for the entire limit line, see "X-Offset" on page 149).
Remote command:
CALCulate:LIMit<k>:CONTrol:SHIFt on page 324
Shift y
Shifts the y-value of each data point vertically by the defined shift width (as opposed to
an additive offset defined for the entire limit line, see "Y-Offset" on page 149).
Remote command:
CALCulate:LIMit<k>:LOWer:SHIFt on page 325
CALCulate:LIMit<k>:UPPer:SHIFt on page 328
Save
Saves the currently edited limit line under the name defined in the "Name" field.
6.8 Zoom Functions
The zoom functions are only available from the toolbar.
For details on the zoom functions see the R&S FSW User Manual.
Single Zoom................................................................................................................153
Multiple Zoom..............................................................................................................153
Restore Original Display............................................................................................. 154
Deactivating Zoom (Selection mode)..........................................................................154
Single Zoom
A single zoom replaces the current diagram by a new diagram which displays an
enlarged extract of the trace. This function can be used repetitively until the required
details are visible.
Remote command:
DISPlay[:WINDow<n>]:ZOOM:STATe on page 335
DISPlay[:WINDow<n>]:ZOOM:AREA on page 334
Multiple Zoom
Zoom Functions