Rohde & Schwarz FSW Series - External Mixer Settings; Input Connector

Configuration
R&S
®
FSW-K7
58User Manual 1173.9240.02 ─ 17
Note that the YIG-preselector is active only on frequencies greater than 8 GHz. There-
fore, switching the YIG-preselector on or off has no effect if the frequency is below that
value.
Remote command:
INPut:FILTer:YIG[:STATe] on page 183
Input Connector
Determines whether the RF input data is taken from the RF INPUT connector (default)
or the optional BASEBAND INPUT I connector. This setting is only available if the Ana-
log Baseband Interface (R&S FSW-B71) is installed and active for input. It is not avail-
able for the R&S FSW67.
For more information on the Analog Baseband Interface (R&S FSW-B71) see the
R&S FSW I/Q Analyzer and I/Q Input User Manual.
Remote command:
INPut:CONNector on page 182
5.4.1.2 External Mixer Settings
The external mixer is configured in the "External Mixer" tab of the "Input" dialog box
which is available when you do one of the following, if the R&S FSW-B21 option is
installed:
●
Press the INPUT/OUTPUT key, then select the "External Mixer Config" softkey.
●
From the "Overview", select "Input", then switch to the "External Mixer" tab under
"Input Source".
Note that external mixers are not supported in MSRA/MSRT mode.
For details on using external mixers see the R&S FSW User Manual.
● Mixer Settings......................................................................................................... 58
● Basic Settings......................................................................................................... 62
● Managing Conversion Loss Tables.........................................................................64
● Creating and Editing Conversion Loss Tables........................................................65
Mixer Settings
In this tab you configure the band and specific mixer settings.
Input and Frontend Settings