Rohde & Schwarz FSW Series - 6.6 Marker Peak List Configuration

Analysis
R&S
®
FSW-K7
145User Manual 1173.9240.02 ─ 17
●
In the "Overview", select "Analysis", and switch to the vertical "Marker Function
Config" tab. Then select the "n dB down" button. Select the "N dB Down Config"
softkey.
n dB down Marker State..............................................................................................145
n dB down Delta Value................................................................................................145
n dB down Marker State
Activates or deactivates the special n dB down marker function.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:STATe on page 319
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:RESult? on page 319
n dB down Delta Value
Defines the delta level from the reference marker 1 used to determine the bandwidth or
time span.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:FREQuency? on page 318
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:TIME? on page 320
6.5.3 Deactivating All Marker Functions
All special marker functions can be deactivated in one step.
Use the "All Functions Off" button in the "Marker Functions" dialog box.
6.6 Marker Peak List Configuration
In the Analog Demodulation application the search limits are not available.
To display the "Marker Peak List" dialog, do one of the following:
●
Press the MKR FUNC key, then select the "Marker Peak List" softkey.
●
In the "Overview", select "Analysis", and switch to the vertical "Peak List" tab.
Marker Peak List Configuration