Rohde & Schwarz FSW Series - 5.5 Trigger Configuration

Configuration
R&S
®
FSW-K7
94User Manual 1173.9240.02 ─ 17
"Manual"
Defines a fixed step size for the center frequency. Enter the step size
in the "Value" field.
Remote command:
[SENSe:]FREQuency:CENTer:STEP:LINK on page 232
[SENSe:]FREQuency:CENTer:STEP:LINK:FACTor on page 233
[SENSe:]FREQuency:CENTer:STEP on page 232
5.5 Trigger Configuration
Triggering means to capture the interesting part of the signal. Choosing the right trigger
type and configuring all trigger settings correctly allows you to detect various incidents
in your demodulated signals.
Optionally, the trigger signal used by the R&S FSW can be output to a connected
device, and an external trigger signal from a connected device can be used by the
R&S FSW.
Trigger settings are identical to the base unit, except for the available trigger sources.
Gating is not available for Analog Demodulation measurements.
For background information on trigger settings, trigger output and working with external
triggers, see the R&S FSW User Manual.
The trigger settings are configured in the "Trigger" dialog box.
► To display this dialog box, do one of the following:
● Select the "Trigger" button in the Analog Demodulation "Overview"
● Select the TRIG key and then the "Trigger Config" softkey.
● Trigger Source Settings.......................................................................................... 95
● Trigger Input and Output Settings...........................................................................99
Trigger Configuration