Rohde & Schwarz FSW Series - 11.4.5 Configuring the Vertical Axis (Amplitude, Scaling); 11.4.5.1 Amplitude Settings

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
233User Manual 1173.9240.02 ─ 17
Parameters:
<CouplingType> SPAN
Couples the step size to the span. Available for measurements
in the frequency domain.
(for RF spectrum result display)
RBW
Couples the step size to the resolution bandwidth. Available for
measurements in the time domain.
(for all result displays except RF spectrum)
OFF
Decouples the step size.
*RST: SPAN
Example:
FREQ:CENT:STEP:LINK SPAN
Manual operation: See "Center Frequency Stepsize" on page 93
[SENSe:
]FREQuency:CENTer:STEP:LINK:FACTor <Factor>
This command defines a step size factor if the center frequency step size is coupled to
the span or the resolution bandwidth.
Parameters:
<Factor> 1 to 100 PCT
*RST: 10
Example:
FREQ:CENT:STEP:LINK:FACT 20PCT
Manual operation: See "Center Frequency Stepsize" on page 93
11.4.5 Configuring the Vertical Axis (Amplitude, Scaling)
The following commands are required to configure the amplitude and vertical axis set-
tings in a remote environment.
● Amplitude Settings................................................................................................ 233
● Configuring the Attenuation...................................................................................235
● Configuring a Preamplifier.....................................................................................237
● Scaling the Y-Axis.................................................................................................238
11.4.5.1 Amplitude Settings
Useful commands for amplitude configuration described elsewhere:
● [SENSe:]ADJust:LEVel on page 269
Configuring the Measurement