Rohde & Schwarz FSW Series - 11.4 Configuring the Measurement; 11.4.1 Managing Standard Settings

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
180User Manual 1173.9240.02 ─ 17
Manual operation: See "Preset Channel" on page 55
11.4 Configuring the Measurement
The following remote commands are required to configure an Analog Demodulation
measurement.
Specific commands:
● Managing Standard Settings.................................................................................180
● Configuring the Input.............................................................................................181
● Configuring the Output..........................................................................................229
● Frequency Settings............................................................................................... 231
● Configuring the Vertical Axis (Amplitude, Scaling)................................................233
● Configuring Data Acquisition.................................................................................240
● Triggering..............................................................................................................244
● Configuring Demodulation.....................................................................................255
● Adjusting Settings Automatically...........................................................................267
● Configuring Standard Traces................................................................................ 270
11.4.1 Managing Standard Settings
You can configure the Analog Demodulation application using predefined standard set-
tings. This allows for quick and easy configuration for commonly performed measure-
ments.
For details see chapter 5.2, "Configuration According to Digital Standards",
on page 51.
For an overview of predefined standards and settings see chapter A.1, "Predefined
Standards and Settings", on page 345.
[SENSe:]ADEMod:PRESet[:STANdard]............................................................................180
[SENSe:]ADEMod:PRESet:RESTore............................................................................... 181
[SENSe:]ADEMod:PRESet:STORe..................................................................................181
[SENSe:]ADEMod:PRESet[:STANdard] <Standard>
This command loads a measurement configuration.
Standard definitions are stored in an xml file. The default directory for Analog Demodu-
lation standards is C:\r_s\instr\user\predefined\AdemodPredefined.
Parameters:
<Standard> String containing the file name.
If you have stored the file in a subdirectory of the directory men-
tioned above, you have to include the relative path to the file.
Return values:
<Standard> The query returns the name of the currently loaded standard.
Configuring the Measurement