Rohde & Schwarz FSW Series - 11.4.4 Frequency Settings; [SENSe:]FREQuency:CENTer

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
231User Manual 1173.9240.02 ─ 17
Parameters:
<Frequency> numeric value
Range: 10 Hz to DemodBW/10 (= 300 kHz for active
demodulation output)
*RST: 100 Hz
Example:
OUTP:ADEM:ONL:AF:CFR 100Hz
Manual operation: See "AC Cutoff Frequency" on page 125
OUTPut:ADEMod[:ONLine]:PHONes <State>
In addition to sending the output to the IF/VIDEO/DEMOD output connector (on the
rear panel of the R&S FSW), it can also be output to headphones connected on the
front panel (PHONES connector).
CAUTION: To protect your hearing, make sure that the volume setting is not too high
before putting on the headphones.
If you do not hear output on the connected headphones despite having enabled both
general online demod output OUTPut:ADEMod[:ONLine][:STATe] on page 230
and this command, adjust the volume setting using the rotary knob on the front panel.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
OUTP:ADEM:PHON ON
Manual operation: See "Phones Output" on page 125
11.4.4 Frequency Settings
[SENSe:]FREQuency:CENTer.........................................................................................231
[SENSe:]FREQuency:CENTer:STEP............................................................................... 232
[SENSe:]FREQuency:CENTer:STEP:LINK....................................................................... 232
[SENSe:]FREQuency:CENTer:STEP:LINK:FACTor...........................................................233
[SENSe:]FREQuency:CENTer <Frequency>
This command defines the center frequency.
Configuring the Measurement