Reference
R&S
®
FSW-K7
345User Manual 1173.9240.02 ─ 17
A Reference
A.1 Predefined Standards and Settings
You can configure the Analog Demodulation application using predefined standard set-
tings. This allows for quick and easy configuration for commonly performed measure-
ments.
For details see chapter 5.2, "Configuration According to Digital Standards",
on page 51.
Provided standard files
The instrument comes prepared with the following standard settings:
●
AM Broadcast
●
FM Narrowband
●
FM Broadcast
●
Frequency Settling
●
None (default settings)
The default storage location for the settings files is: C:/FSW/user/predefined/
AdemodPredefined.
Predefined settings
The following parameters can be stored in a standard settings file. Any parameters that
are not included in the xml file are set to their default values when the standard is loa-
ded.
Measurement settings:
●
DBW
●
AQT
●
Demod Filter
●
Sweep Points
●
Squelch (State, Level)
●
Units (Phase, THD)
●
RF Span
Window display settings:
●
Position
●
State
●
Window number
●
Window type (all evaluation methods supported by the Analog Demodulation appli-
cation; see chapter 3, "Measurements and Result Displays", on page 15)
●
Scaling (Ref Position, Dev per Division)
Predefined Standards and Settings
To Next Page
Loading...
