Rohde & Schwarz FSW Series - 6 Analysis; 6.1 Trace Settings

Analysis
R&S
®
FSW-K7
129User Manual 1173.9240.02 ─ 17
6 Analysis
General result analysis settings concerning the trace, markers, lines etc. can be config-
ured via the "Analysis" button in the "Overview". They are identical to the analysis func-
tions in the base unit except for the special marker functions.
The remote commands required to perform these tasks are described in chapter 11,
"Remote Commands for Analog Demodulation Measurements", on page 170.
6.1 Trace Settings........................................................................................................... 129
6.2 Trace / Data Export Configuration...........................................................................133
6.3 Marker Settings......................................................................................................... 134
6.3.1 Individual Marker Setup.............................................................................................. 135
6.3.2 General Marker Settings............................................................................................. 137
6.4 Marker Search Settings and Positioning Functions.............................................. 139
6.4.1 Marker Search Settings...............................................................................................139
6.4.2 Positioning Functions..................................................................................................140
6.5 Marker Function Configuration................................................................................142
6.5.1 Phase Noise Measurement Marker.............................................................................143
6.5.2 n dB Down Marker...................................................................................................... 144
6.5.3 Deactivating All Marker Functions...............................................................................145
6.6 Marker Peak List Configuration............................................................................... 145
6.7 Limit Line Settings and Functions.......................................................................... 147
6.7.1 Limit Line Management...............................................................................................147
6.7.2 Limit Line Details.........................................................................................................150
6.8 Zoom Functions........................................................................................................ 153
6.9 Analysis in MSRA/MSRT Mode................................................................................ 154
6.1 Trace Settings
You can configure the settings for up to 6 individual traces.
Trace settings can be configured via the TRACE key, in the "Traces" dialog box, or in
the vertical "Traces" tab of the "Analysis" dialog box.
In the Analog Demodulation application when you configure the traces for a window
with a specific evaluation (e.g. AM time domain), the traces in all windows with the
same evaluation are configured identically.
Trace Settings