Rohde & Schwarz FSW Series - 6.5.1 Phase Noise Measurement Marker

Analysis
R&S
®
FSW-K7
143User Manual 1173.9240.02 ─ 17
The remote commands required to define these settings are described in chap-
ter 11.8.1.5, "Configuring Special Marker Functions", on page 312.
The Fixed Reference Marker settings are described in "Defining a Fixed Reference"
on page 138.
● Phase Noise Measurement Marker.......................................................................143
● n dB Down Marker................................................................................................ 144
● Deactivating All Marker Functions.........................................................................145
6.5.1 Phase Noise Measurement Marker
For each of the 16 markers phase noise measurement can be activated. Phase noise
measurement markers are configured in the "Phase Noise Config" dialog box, using
the "Phase Noise" function.
The individual marker settings correspond to those defined in the "Marker" dialog box.
Any settings to the marker state or type changed in the "Marker Function" dialog box
are also changed in the "Marker" dialog box and vice versa.
To display the "Phase Noise Config" dialog box, do one of the following:
●
Press the MKR FUNC key, then select the "Select Marker Function" softkey. Then
select the "Phase Noise" button. Select the "Phase Noise Config" softkey.
●
In the "Overview", select "Analysis", and switch to the vertical "Marker Function
Config" tab. Then select the "Phase Noise" button. Select the "Phase Noise Con-
fig" softkey.
Marker Function Configuration