Rohde & Schwarz FSW Series - Analog Baseband Input Settings

Configuration
R&S
®
FSW-K7
71User Manual 1173.9240.02 ─ 17
Note: If you close the R&S DigIConf window using the "Close" icon, the window is
minimized, not closed.
If you select the "File > Exit" menu item in the R&S DigIConf window, the application is
closed. Note that in this case the settings are lost and the EX-IQ-BOX functionality is
no longer available until you restart the application using the "DigIConf" softkey in the
R&S FSW once again.
5.4.1.4 Analog Baseband Input Settings
The following settings and functions are available to provide input via the Analog Base-
band Interface (R&S FSW-B71) in the applications that support it.
They can be configured via the INPUT/OUTPUT key, in the "Input" dialog box.
For more information on the Analog Baseband Interface (R&S FSW-B71) see the
R&S FSW I/Q Analyzer and I/Q Input User Manual.
Analog Baseband Input State....................................................................................... 71
I/Q Mode....................................................................................................................... 71
Input configuration.........................................................................................................72
Center Frequency......................................................................................................... 72
Analog Baseband Input State
Enables or disable the use of the "Analog Baseband" input source for measurements.
"Analog Baseband" is only available if the Analog Baseband Interface (R&S FSW-B71)
is installed.
Remote command:
INPut:SELect on page 184
I/Q Mode
Defines the format of the input signal.
For more information on I/Q data processing modes see the R&S FSW I/Q Analyzer
and I/Q Input User Manual.
Input and Frontend Settings