Rohde & Schwarz FSW Series - 11.4.2 Configuring the Input

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
181User Manual 1173.9240.02 ─ 17
Manual operation: See "Load Standard" on page 53
[SENSe:]ADEMod:PRESet:RESTore
This command restores the default configurations of predefined Analog Demodulation
standards.
Note that the command will overwrite customized standards that have the same name
as predefined standards.
Usage: Event
Manual operation: See "Restore Standard Files" on page 53
[SENSe:]ADEMod:PRESet:STORe <Standard>
This command saves the current Analog Demodualtion measurement configuration.
Standard definitions are stored in an xml file. The default directory for Analog Demodu-
altion standards is C:\r_s\instr\user\predefined\AdemodPredefined.
Parameters:
<Standard> String containing the file name.
You can save the file in a subdirectory of the directory men-
tioned above. In that case, you have to include the relative path
to the file.
Manual operation: See "Save Standard" on page 53
11.4.2 Configuring the Input
● RF Input................................................................................................................ 181
● Using External Mixers........................................................................................... 184
●
Configuring Input via the Analog Baseband Interface (R&S FSW-B71)............... 198
● Configuring Digital I/Q Input and Output............................................................... 202
● Setting up Probes..................................................................................................206
● Working with Power Sensors................................................................................ 208
● External Generator Control................................................................................... 219
11.4.2.1 RF Input
INPut:ATTenuation:PROTection:RESet............................................................................182
INPut:CONNector...........................................................................................................182
INPut:COUPling.............................................................................................................182
INPut:FILTer:HPASs[:STATe]..........................................................................................183
INPut:FILTer:YIG[:STATe].............................................................................................. 183
INPut:IMPedance...........................................................................................................183
INPut:SELect.................................................................................................................184
Configuring the Measurement