Rohde & Schwarz FSW Series - 11.4.2.3 Configuring Input via the Analog Baseband Interface (R&S FSW-B71)

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
198User Manual 1173.9240.02 ─ 17
11.4.2.3
Configuring Input via the Analog Baseband Interface (R&S FSW-B71)
The following commands are required to control the Analog Baseband Interface
(R&S FSW-B71) in a remote environment.They are only available if this option is instal-
led.
For more information on the Analog Baseband Interface see the R&S FSW I/Q Ana-
lyzer User Manual.
Useful commands for Analog Baseband data described elsewhere:
● INP:SEL AIQ (see INPut:SELect on page 184)
● [SENSe:]FREQuency:CENTer on page 231
Commands for the Analog Baseband calibration signal are described in the R&S FSW
User Manual.
Remote commands exclusive to Analog Baseband data input and output
INPut:IQ:BALanced[:STATe]........................................................................................... 198
INPut:IQ:FULLscale:AUTO..............................................................................................198
INPut:IQ:FULLscale[:LEVel]............................................................................................ 199
INPut:IQ:TYPE.............................................................................................................. 199
CALibration:AIQ:DCOFfset:I............................................................................................200
CALibration:AIQ:DCOFfset:Q.......................................................................................... 200
[SENSe:]PROBe<ch>:SETup:CMOFfset.......................................................................... 201
TRACe:IQ:APCon[:STATe]............................................................................................. 201
TRACe:IQ:APCon:A....................................................................................................... 201
TRACe:IQ:APCon:B....................................................................................................... 202
TRACe:IQ:APCon:RESult?............................................................................................. 202
INPut:IQ:BALanced[:STATe] <State>
This command defines whether the input is provided as a differential signal via all 4
Analog Baseband connectors or as a plain I/Q signal via 2 simple-ended lines.
Parameters:
<State> ON
Differential
OFF
Simple-ended
*RST: ON
Example:
INP:IQ:BAL OFF
Manual operation: See "Input configuration" on page 72
INPut:IQ:FULLscale:AUTO <State>
This command defines whether the full scale level (i.e. the maximum input power on
the Baseband Input connector) is defined automatically according to the reference
level, or manually.
Configuring the Measurement