Rohde & Schwarz FSW Series - Page 202

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
202User Manual 1173.9240.02 ─ 17
Parameters:
<ConvFact> numeric value
*RST: 1.0
TRACe:IQ:APCon:B <ConvFact>
Defines the conversion factor B for the calculation of the average power consumption.
For details see the R&S FSW I/Q Analyzer and I/Q Input User Manual.
Parameters:
<ConvFact> numeric value
*RST: 0.0
TRACe:
IQ:APCon:RESult?
Queries the average power consumption for an analog baseband input. This value is
only calculated at the end of the I/Q data measurement if the TRACe:IQ:APCon[:
STATe] command is set to ON before the measurement is performed!
For details see the R&S FSW I/Q Analyzer and I/Q Input User Manual.
Parameters:
<Average> numeric value
Default unit: W
Usage: Query only
11.4.2.4 Configuring Digital I/Q Input and Output
Useful commands for digital I/Q data described elsewhere:
● INP:SEL DIQ (see INPut:SELect on page 184)
● TRIGger[:SEQuence]:LEVel:BBPower on page 247
Configuring the Measurement