Configuration
R&S
®
FSW-K7
54User Manual 1173.9240.02 ─ 17
In addition to the main measurement settings, the "Overview" provides quick access to
the main settings dialog boxes. Thus, you can easily configure an entire Analog
Demodulation measurement channel from input over processing to output and analysis
by stepping through the dialog boxes as indicated in the "Overview".
In particular, the "Overview" provides quick access to the following configuration dialog
boxes (listed in the recommended order of processing):
1. Input/Frontend
See chapter 5.4, "Input and Frontend Settings", on page 55
2. Trigger
See chapter 5.5, "Trigger Configuration", on page 94
3. Data Acquisition
See chapter 5.6, "Data Acquisition", on page 101
4. Demod/Display
See chapter 5.7, "Demodulation Display", on page 106
5. Demodulation Settings
See chapter 5.8, "Demodulation", on page 106
6. Analysis
See chapter 6, "Analysis", on page 129
7. (Optionally:) Outputs
See chapter 5.9.1, "Output Settings", on page 121
To configure settings
► Select any button in the "Overview" to open the corresponding dialog box.
Select a setting in the channel bar (at the top of the measurement channel tab) to
change a specific setting.
Configuration Overview
To Next Page
Loading...
