Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
336User Manual 1173.9240.02 ─ 17
1 = origin of coordinate system (x1 = 0, y1 = 0)
2 = end point of system (x2 = 100, y2= 100)
3 = zoom area (e.g. x1 = 60, y1 = 30, x2 = 80, y2 = 75)
Suffix:
<zoom>
.
1...4
Selects the zoom window.
Parameters:
<x1>,<y1>,
<x2>,<y2>
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range: 0 to 100
Default unit: PCT
Manual operation: See "Multiple Zoom" on page 153
DISPlay[:WINDow<n>]:ZOOM:MULTiple<zoom>:STATe <State>
This command turns the mutliple zoom on and off.
Suffix:
<zoom>
.
1...4
Selects the zoom window.
If you turn off one of the zoom windows, all subsequent zoom
windows move up one position.
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "Multiple Zoom" on page 153
See "Restore Original Display" on page 154
See "Deactivating Zoom (Selection mode)" on page 154
11.8.4 Configuring an Analysis Interval and Line (MSRA mode only)
In MSRA operating mode, only the MSRA Master actually captures data; the MSRA
applications define an extract of the captured data for analysis, referred to as the
analysis interval. The analysis line is a common time marker for all MSRA applica-
tions.
Analyzing Results
To Next Page
Loading...
