Rohde & Schwarz FSWP Series - Page 120

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
120User Manual 1177.5856.02 ─ 07
TRIGger[:SEQuence]:DTIMe...........................................................................................120
TRIGger[:SEQuence]:HOLDoff[:TIME]..............................................................................120
TRIGger[:SEQuence]:IFPower:HOLDoff...........................................................................120
TRIGger[:SEQuence]:IFPower:HYSTeresis.......................................................................121
TRIGger<tp>[:SEQuence]:LEVel[:EXTernal<port>]............................................................ 121
TRIGger[:SEQuence]:LEVel:IFPower............................................................................... 122
TRIGger[:SEQuence]:LEVel:IQPower...............................................................................122
TRIGger[:SEQuence]:LEVel:RFPower..............................................................................122
TRIGger[:SEQuence]:SLOPe.......................................................................................... 123
TRIGger[:SEQuence]:SOURce........................................................................................123
TRIGger[:SEQuence]:TIME:RINTerval..............................................................................124
TRIGger[:SEQuence]:DTIMe <DropoutTime>
Defines the time the input signal must stay below the trigger level before a trigger is
detected again.
Parameters:
<DropoutTime> Dropout time of the trigger.
Range: 0 s to 10.0 s
*RST: 0 s
Default unit: S
Manual operation: See " Drop-Out Time " on page 57
TRIGger[:SEQuence]:HOLDoff[:TIME] <Offset>
Defines the time offset between the trigger event and the start of the measurement.
Parameters:
<Offset> For measurements in the frequency domain, the range is 0 s to
30 s.
For measurements in the time domain, the range is the negative
measurement time to 30 s.
*RST: 0 s
Default unit: S
Example:
TRIG:HOLD 500us
Manual operation: See " Trigger Offset " on page 57
TRIGger[:SEQuence]:IFPower:HOLDoff <Period>
This command defines the holding time before the next trigger event.
Note that this command can be used for any trigger source, not just IF Power
(despite the legacy keyword).
Note: If you perform gated measurements in combination with the IF Power trigger, the
R&S FSWP ignores the holding time for frequency sweep, FFT sweep, zero span and
I/Q data measurements.
Configuring I/Q Analyzer Measurements