Rohde & Schwarz FSWP Series - Page 39

Configuration
R&S
®
FSWP
39User Manual 1177.5856.02 ─ 07
I/Q data can only be imported and exported in applications that process I/Q data, such
as the I/Q analyzer or other optional applications.
See the corresponding user manuals for those applications for details.
These functions are only available if no measurement is running.
In particular, if Continuous Sweep / Run Cont is active, the import/export functions are
not available.
Import ...........................................................................................................................39
└ I/Q Import .......................................................................................................39
Export ...........................................................................................................................39
└ Export Trace to ASCII File ............................................................................. 39
└ File Type .............................................................................................. 40
└ Decimal Separator ...............................................................................40
└ Trace Export Configuration ............................................................................ 40
└ I/Q Export .......................................................................................................40
Import
Access: "Save/Recall" > Import
Provides functions to import data.
I/Q Import ← Import
Opens a file selection dialog box to select an import file that contains I/Q data. This
function is only available in single sweep mode and only in applications that process
I/Q data, such as the I/Q Analyzer or optional applications.
Input from I/Q data files is imported as it was stored, including any correction factors,
for example from transducers or SnP files. Any currently configured correction factors
at the time of import, however, are not applied.
I/Q import is not available in MSRA mode.
Remote command:
MMEMory:LOAD:IQ:STATe on page 148
Export
Access: "Save/Recall" > Export
Opens a submenu to configure data export.
Export Trace to ASCII File ← Export
Saves the selected trace or all traces in the currently active result display to the speci-
fied file and directory in the selected ASCII format.
Import/Export Functions