29
Connecting External Equipment
This carries out multi-track playback (up to 48 tracks) on the R-1000, with output to a V-Mixer. Signal from the V-Mixer is output to
a digital snake device. This connection setup enables you to carry out a sound check even when there are no source instruments
or the performers are unavailable.
For this connection, set the REAC setting on the R-1000 to “SOUND CHECK.” Refer to “About REAC Settings” (p. 36).
* Connect the R-1000’s [TO SLAVE/SPLIT] REAC port (C/D) to the digital snake devices at the stage.
* Connect REAC A/B on the V-Mixer to the [TO MASTER] REAC port on the R-1000. Be careful not to mix up the A and B connections.
fig.sound-check.eps
Set the REAC modes on the devices as shown below. For information on setting the REAC modes on the V-Mixer and the digital
snake device, refer to the owner’s manual for each products.
• V-Mixer Master
• Digital snake device Slave
Example 3: Performing Multi-track Playback on the R-1000
A
B
M-380
S-1608 S-1608
STAGE
FOH (Front of House)
REAC Master/Split Device
REAC Master Device
REAC
Slave
Device
REAC
Slave
Device
48ch
ABCD
To Next Page
Loading...
