74
Appendices
Cannot record/Cannot play.
Sampling frequency mismatch.
The sampling frequency of the selected project does not match with the REAC system where the R-1000 is currently connected. It
is not possible to carry out recording/playback.
Cannot change.
REAC SETUP is not EXT.CLOCK.
The REAC SETUP is not [EXT.CLOCK with V-MIXER] nor [EXT.CLOCK with D.SNAKE]. It is not possible to change the setting.
Cannot operate the EXTERNAL STORAGE.
It exceeds the power capability.
The power consumption of the device connected to the EXTERNAL STORAGE connector is exceeds the maximum (2.5 W).
Now recording../Now playing...
Your operation cannot be performed during recording or playback.
Insert REMOVABLE STORAGE.
Insert optional removable storage to the removable storage bay.
EXTERNAL STORAGE is not formatted.
The connected external storage is not formatted yet. Carry out formatting.
Media is full.
Since the capacity of the removable storage or external storage is fully consumed, you cannot continue recording or copying.
Splitting file..
Now splitting the file. (This appears when the file size of recorded data reaches 2 GB or a manual split is being performed by
pressing [REC] button while recording.)
Cannot split.
You cannot perform further splitting (take number reached 99).
REAC x error.
Fan stop.
The cooling fan of the unit connected to REAC port x has stopped.
REAC x error.
Temp high.
The interior temperature of the unit connected to REAC port x is abnormally high.
REAC x error.
Link down.
The link with the unit connected to REAC port x has been disconnected while recording or playback.
Internal fan has stopped.
The cooling fan on rear panel has stopped.
Internal battery is low.
Internal lithium battery is dying. Replace battery as described earlier.
PREAMP CONTROL is disabled.
It is not possible to change the preamp setting of input/output units.
Cannot lock external clock. (No signal/Unlock)
It is not possible to synchronize with clock from external source. (R-1000 is not detecting signal or improper signal is input.)
Error Messages