Roland R-1000

36
About REAC Settings
Choose a REAC setting on the R-1000 from below to match the connected devices and usage.
fig.REAC-mode-selection.eps
1. Display the setting menu.
Press the [MENU] button to display the menu screen, then select [REAC CONFIG].
fig.open-REAC-menu.eps
2. Select the setting.
Select [REAC SETUP], then select a setting from the four selections described above.
fig.select-REAC-mode.eps
3. Go back to the home screen.
Press the [MENU] button to return to the home screen.
The REAC mode of the R-1000’s REAC connectors A and B and the clock-source setting range are determined by the settings as shown below.
fig.operation-mode.eps
REC ONLY
SOUND CHECK
EXT. CLOCK with V-MIXER
EXT. CLOCK with D.SNAKE
Select this when recording split output from the V-Mixer.
Select this when connecting the V-Mixer or digital snake device and carrying out
recording, playback, or sound checks.
Select this when synchronizing to an external word clock in a system where
the V-Mixer is connected.
Select this when synchronizing to an external word clock in a system where
a digital snake device is connected.
REC ONLY
SOUND CHECK
EXT. CLOCK with V-MIXER
EXT. CLOCK with D.SNAKE
REAC Mode Clock Source
Split
Slave
Slave
Master
Fixed to REAC
Fixed to REAC
All selectable
All selectable