Roland R-1000

53
Performing Multi-track Playback
1. Select the playback mode.
Choose one playback mode from below. The playback mode changes each time you touch the icon, in the sequence shown.
• One Shot This plays the current song once (one shot), then stops.
• Loop This performs repeated (loop) playback of the current song.
• Sequential This plays the songs in current project sequentially, starting with the current song.
Playback stops when the playback of the song right before the current song is finished.
• Sequential Loop This performs sequential loop playback of the songs in current project, starting with the current song.
• Marker Loop This performs loop playback between markers before and after the current location.
fig.play-mode.eps
2. Start/stop playback.
Pressing the [PLAY] button starts playback. Pressing the [STOP] button stops playback.
fig.start-playback.eps
When you want to jump to the beginning of the song, press the button shown below to make the jump to the beginning. Press the same button
twice to switch to the previous song.
fig.zero-button.eps
You can control the output levels of the tracks remotely from the following devices.
• V-Mixer
• S-4000R connected to a digital snake device
• S-4000 RCS (dedicated remote-control software) connected to a digital snake device
* To adjust output levels by remote control, you must set the R-1000 to receive remote control commands. Refer to “Virtual Preamp Setting
Screen” (p. 68).
Starting Playback
One Shot Loop Sequential Sequential Loop Marker loop
Song sequence is determined by the song names
(numerical and alphabetical order).