68
About the Home Screen
Virtual Preamp Setting Screen
Touching the [Virtual] icon at the track status screen makes the display change to the following screen.
fig.virtual.eps
You can virtually adjust the playback volume of a selected track in this screen remotely from the devices listed below.
• V-Mixer
• S-4000R connected to a digital snake device
• S-4000 RCS (dedicated remote-control software) connected to a digital snake device
1. ALL Selector
This enables you to adjust the playback volume for all tracks from the external equipment.
2. Track Selectors
These select the tracks for virtual adjustment of volume. You can virtually adjust the volume level only for numbers highlighted in
green by touching them.
If you have assigned input channels according to [Assign the input channels to the recording tracks] (p. 44), the physical preamp of the assigned
channel on the source device will also change. You can check which channel is assigned to which track in [INPUT PATCHBAY].
21
To Next Page
Loading...
Need help?
General
