48
Performing Multi-track Recording
Switching Level Meter Settings
At the front panel, holding down the [SHIFT] button and pressing the [PEAK CLEAR] button makes the display change to the
meter setup screen. Before you start recording, customize the behavior of the audio levels display.
fig.call-meter-setup.eps
At this screen, you can change the following parameters.
PEAK HOLD
This turns on/off the peak hold.
HOLD
This sets the peak hold time. It is effective only when [PEAK HOLD] is set to [ON].
OVER LEVEL
This sets the decibels at which the [OVER] lamp lights up.
RANGE
This determines the lower limit of the level meter.
The images below show the available changes you can make to the Meter Setup parameters.
fig.meter-setup-parameter.eps
When you have selected a setting value, be sure to touch the [Done] icon to apply it.
PEAK HOLD HOLD TIME
OVER LEVEL RANGE
To Next Page
Loading...
