50
Press to display the screen on the left.
Press
.
The media is cut o.
You can make the setting in the software RIP for automatic media cuto after printing has nished. For
information on how to make the setting, refer to the documentation for the software RIP you are using.
(70%6+10
5*''6%76
About cutoff operation
When the media clamps are attached, the screen shown
on the left appears. Open the front cover, remove the left
and right media clamps, and press
.
Be sure to remove the media clamps. If you attempt to perform the cuto operation while the
media clamps are attached, the machine will detect them and interrupt the operation.
Even if you enable the automatic media-cuto function in the software RIP, if the media clamps
are attached, the machine will detect them and interrupt the operation.
When performing cuto, do not use
to pull the media back. Unless the end of the media
has been pulled out to a location to the front of the platen, cuto may not be performed smoothly.
Give attention to media composition
For some types of media, cuto is not possible.
Some types of media may remain on the platen after cuto. If the media remains on the platen,
remove it by hand.
To Next Page
Loading...
