With [AA] displayed
Use the
+
and
-
key to select the
required actuator operating time. The
settings are displayed in percentage of
maximum rated speed.
PRESS THE KEY.
The displayed value will flash, indicating
that it has been set.
All speed settings are adjustable in
percentage increments. Any value of %
outside of the range stated will not be
accepted into the actuator memory.
NOTE: Mains power has to be on
for speed setting to be carried out.
25
Speed Setting
AA
IQT operating time can be adjusted between 25% and 100% of the maximum
time (50% and 100% for IQT2000). IQT are factory set at the maximum speed.
IQTM actuators are dispatched with the minimum speed set. To access speed
setting [AA] screen, bus system [OP] has to be set to [On], using the
+
and
-
key.
After this setting, proceed to screen [AA].
IQT Speed
100%
Positional Display
m
m
P?
k
PC
k
Ir
k
tP
m
Contact Function
cr
k
Contact S1
r1
m
Contact S2
r2
m
Contact S3
r3
m
Contact S4
r4
m
ESD Action
Control Mode
Configuration
A1
m
Extra Indication Remote
Contacts CPT
Control Source
Option Selection OE k OI k Od
m
FL
m
PA
m
IQT Speed IQT Type
Setting Setting
AA k Ab
50
IrDA
comms
Primary
Functions
m
To Next Page
Loading...
Need help?
General
