Ruckus Wireless ZoneFlex 2925 - Configuring for Standalone Operation or for Management by Flexmaster

23
Installing the Access Point
Step 1: Preconfigure the Access Point
When the Status column shows Connected, this indicates that the Access Point has
successfully registered with ZoneDirector and that it can now be moved to its
destination Layer 2 or Layer 3 network.
3. Disconnect the Access Point from the Power Source
1. Disconnect the Access Point from the power source.
2. Verify that the power LED on the rear panel of the Access Point is off.
3. Continue to “Step 3: Deploy the Access Point” on page 34.
Configuring for Standalone Operation or for
Management by FlexMaster
This section describes the steps you need to complete to set up the AP in standalone
mode or to be managed by Ruckus Wireless FlexMaster, if you have one installed on
the network.
What You Will Need
Before starting with the configuration task, make sure that you have the following
requirements ready:
■ An administrative computer (notebook computer) running on Microsoft Windows
Vista/XP/2000
■ Mozilla Firefox 2.0 (or later) or Microsoft Internet Explorer 6.0 (or later) installed on
the administrative computer
■ One 5.6mm-6.0mm (outside diameter) Cat5e foil screened twisted pair (FTP) solid
cable
■ Two Ethernet cables
1. Prepare the Administrative Computer
NOTE: The following procedure is applicable if the administrative computer is
running on Windows XP or Windows 2000. If you are using a different operating
system, refer to the documentation that was shipped with your operating system for
information on how to modify the computer’s IP address settings.
1. On your Windows XP or Windows 2000 computer, open the Network Connec-
tions (or Network and Dial-up Connections) control panel according to how the
Start menu is set up:
• On Windows XP, click Start > Control Panel > Network Connections.
• On Windows 2000, click Start > Settings > Network Connections.