41
4
Configuring the Access Point
Configuring the System Settings
The system settings refer to the device name, temperature update, and service
provider login settings.
1. Go to Configuration > Device. The Configuration :: Device page appears.
2. In Device Name, type a new name for the device or leave as is to accept the default
device name (RuckusAP). The device name identifies the AP among other devices
on the network.
3. In Temperature Update, specify how often you want the AP to update its
temperature information on the Status > Device page. The default update interval
is 30 seconds.
4. Under Service Provider Login, change the login information as required:
• Username: Type the name that you want to use for logging into the Web
interface. The default user name is super.
• Current Password: Type the current administrative password. The default
administrative password is sp-admin.
• New Password: Type the new password that you want to use. The password
must consist of six to 32 alphanumeric characters only.
• Confirm Password: Retype the new password to confirm.
5. Click Update Settings to save and apply your changes.
In This Chapter
Configuring the System Settings
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .41
Configuring Network Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42
Configuring Common Wireless Settings
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .46
Controlling Access to the Wireless Network
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .59
Configuring VLAN Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .62
To Next Page
Loading...
