59
Configuring the Access Point
Controlling Access to the Wireless Network
Controlling Access to the Wireless Network
Access Control give you control over which stations are allowed to join (associate with)
your WLAN networks. There are “tab” entries for each available WLAN.
Changing the Access Controls for a WLAN
1. Go to Configuration > Wireless.
NOTE: If you are using ZoneFlex 7962 AP, go to Configuration > Radio 2.4G or
Configuration > Radio 5G.
2. Click the Wireless # tab for which you want to configure the access control
settings.
3. Click the Edit Settings button after Access Control. The Configuration :: Wireless
:: Access Control :: Wireless # page appears.
4. Select the radio button for the desired access control. (For a description of the
options, see“Changing the Access Controls for a WLAN”
in the previous section.)
The Access Controls Table appears.
5. Click Add new entry to add a MAC address to the table.
6. Type the MAC address in the spaces provided.
7. Click Update to save your changes. Assuming all parameters you entered are
acceptable, that row will be added to the table.
You have completed adding an entry to the MAC address table. If you have additional
MAC addresses you want included, click Add new entry, and then repeat these steps
until you have entered all the stations you want. There is a limit of 128 rows.
To Next Page
Loading...
