58
Configuring the Access Point
Configuring WLAN Settings
NOTE: If you are using ZoneFlex 7962 AP, go to Configuration > Radio 2.4G or
Configuration > Radio 5G.
2. Click a Wireless # tab to configure. The Configuration :: Wireless :: Wireless[#]
page appears.
3. Click the Encryption Method menu, then click WPA. The basic set of WPA-specific
encryption options appear on the page.
4. Select 802.1x as the WPA Authentication mode. Additional options appears.
5. Configure the following settings to customize your 802.1x authentication.
• RADIUS NAS-ID: Enter the network ID assigned to your RADIUS server.
• Authentication Server [-Required-]: Enter the information needed to estab-
lish a connection between the AP and the RADIUS server.
• Accounting Server [-Optional-]: Enter the information needed to establish
this connection.
6. Click Update Settings to save and apply the changes. A confirmation message
appears at the top of this page.
7. Click Go back to Wireless Configuration to reopen the previous page.
Figure 28. 802.1x settings
To Next Page
Loading...
