27
Installing the Access Point
Step 1: Preconfigure the Access Point
Configure Common Wireless Settings
1. On the left menu of the Web interface, click Configuration > Wireless. The
Common page appears.
NOTE: ZoneFlex 7962 AP has two radios (2.4GHz and 5GHz) that need to be
configured separately on the Web interface. To configure the common wireless
settings, click Configuration > Radio 2.4G or Radio 5G. The rest of the configuration
procedures are the same as the other models.
2. Verify that the common wireless settings are configured as listed in Table 1 3.
3. If you made any changes to the Common tab, click Update Settings.
4. Continue to “Configure Wireless # Settings”
below.
Table 13. Common wireless configuration
Setting Recommended Value
Wireless Mode Auto-select
Channel SmartSelect
Country Code • If you purchased the Access Point in the United
States, this value is fixed to United States at the
factory and is not user configurable.
• If you purchased the Access Point outside the
United States, verify that the value is set to your
country or region. Selecting the correct country
code ensures that the Access Point uses only the
radio channels allowed in your country or region.
Note for ZoneFlex 7962 AP users: The two radios on
ZoneFlex 7962 AP are always configured with the same
country code setting. If you change the country code
for Radio 1, for example, the same change will be
applied automatically to Radio 2.
To Next Page
Loading...
