DescriptionOption
This is the publicly-broadcast “name” of your wireless network.
SSIDs can contain up to 32 alphanumeric characters and are
case-sensitive. The SSID can only contain between 2 and 32
characters, including characters from ! (char 33) to ~ (char 126).
SSID
This button opens a page where you can configure the Protection
Mode you activated on the Configuration > Wireless > Advanced
> Wireless [#] page. If Protection Mode is not active, ignore this
option. For more information, refer to
Setting Threshold Options on page 112.
Threshold
Settings
This button opens a page where you can configure upload and
download limits per station. For more information, refer to
Rate Limiting on page 113.
Rate Limiting
This button opens a page where you can configure access
controls for the WLAN. For more information, refer to
Controlling Access to the Wireless Network on page 114.
Access Control
• Isolated: Selecting Isolated causes the traffic from this WLAN
to terminate at the AP.
• Bridge to WAN: The default setting, Bridge to WAN forwards
packets arriving on this WLAN to the WAN (uplink) port and
eventually to their external destinations using Layer 2
forwarding.
• Local Subnet NAT and Route to WAN: This setting allows
routing of wireless packets to their destinations using Layer
3 network address translation (NAT).
• Bridge to L2TP Tunnel: Uses Layer 2 Tunneling Protocol to
deliver packets encapsulated with an L2TP header in UDP
datagrams.
Packet Forward
Select a Hotspot configuration from the list to enable Hotspot
service on this WLAN, if you have configured it from the
Configuration > Hotspot page. See
Configuring Hotspot Service on page 121.
Hotspot Service
This option appears if you have selected
Local Subnet NAT and Route to WAN under
Packet Forwarding, and allows you to choose which subnet
this WLAN's traffic is part of. You must have previously configured
a subnet from the Configuration > Local Subnets page before
it becomes available here.
Local Subnet
Enter a VLAN ID to segment all traffic arriving from this WLAN to
a specified VLAN. Default is 1.
Access VLAN
ZoneFlex Indoor Access Point Release 104.0 User Guide
105
Configuration
Configuring the AP
To Next Page
Loading...
