Changing the Access Controls for a WLAN
Use the Access Control page to configure access to the wireless network.
By default, the Disable WLAN access restrictions option is selected, which allows any
wireless station to access the wireless network. If you want to change this setting, follow
the instructions below.
1. Go to Configuration > Wireless or Configuration > Radio 2.4G or Configuration
> Radio 5G.
2. Click the Wireless # tab for the WLAN for which you want to enable access controls.
3. Click the Edit Settings button next to Access Control. The Access Control page
appears.
4. Click Allow only stations listed in the Access Controls Table or Deny only stations
listed in the Access Controls Table. (For a description of the options, refer to
Access Control Options on page 114.)
The Access Control Table appears.
Figure 60: Access control settings
5. To add a MAC address to the Access Control Table, click Add new entry.
6. Fill out the following text boxes:
• Address: Six text boxes appear in which you enter the desired MAC address, in
hexadecimal format, two characters in each box. Allowable hex-digit characters
are 0-9, a-f, and A-F.
7. Click Update to save your changes. Assuming all parameters you entered are
acceptable, that row is added to the table.
ZoneFlex Indoor Access Point Release 104.0 User Guide
115
Configuration
Configuring the AP
To Next Page
Loading...
