DescriptionOption
AUTO = allow the AP to decide if it is to
operate off of 802.3at or 802.3af power
over Ethernet, or 802.3af PoE = force the
AP to operate off of 802.3af power over
Ethernet. Default = AUTO.
NOTE As described in the
ZoneFlex R710 on page 65 section, the
R710 AP can operate off of 802.3af
power, but the feature set is reduced.
PoE Operating Mode (some APs)
Refer to Set Controller Address/Enabled
above.
Primary and Controller Addr
3. If you want to use TR-069 or SNMP to manage the AP, then configure the settings
listed in the following table.
Table 55: TR-069 and SNMP Management Options
DescriptionOption
Enables the Ruckus Wireless device to
be managed by either SNMP server,
Ruckus Wireless ZoneDirector, or Ruckus
Wireless FlexMaster.
Auto
Only allow SNMP management.SNMP only
Only allow FlexMaster management.FlexMaster only
URL of server providing DHCP.DHCP Discovery
URL of the FlexMaster server.FlexMaster Server URL
This information is automatically
generated by the AP and used for
authentication with FlexMaster. Change
this value only if you want the AP to
connect to another access control server
(ACS).
Digest-authentication
Username/Digest-authentication
password
Interval at which the device should
attempt to contact FlexMaster. Default =
15 minutes.
Periodic FlexMaster Inform Interval
ZoneFlex Indoor Access Point Release 104.0 User Guide
137
Administration
Enabling Other Management Access Options
To Next Page
Loading...
