P-Mode Programming SER-7000 Program Manual
Validation/Subtotal Print Options Program Notes
NOTE: To validate, you must attach a printer with validation capability to each
register that will validate. Use option #7 to identify the port to which the printer is
attached.
# FIELD Notes
1 VALIDATION AMT:
Y=TOTAL/N=TENDER
For sale validation, you can select either the
amount of the sale or the amount of the tender
as the amount to print on the validation.
2 CHK VALID AMT:
Y=TTL/N=TEND
For check sale validation, you can select
either the amount of the sale or the amount of
the tender as the amount to print on the
validation.
3 ACTIVATE VALIDATION
SENSOR
The printer must be equipped with validation
option and sensor.
4 ALLOW MULTIPLE
VALIDATIONS
If Y, the validation can be done more than
once.
5 PRINT VALIDATION
MESSAGE
See "Validation Message" on page 57 to
program a message of up to three lines.
6 PRINT SBTL WHEN SBTL
PRESSED
If Y, the receipt (if applicable) will print the
subtotal at the point in the transaction when
the key was pressed.
7 VALIDATION PORT# (0-4)
Indicate the port on the register that is
connected to the validation printer.
8 DISPLAY RUNNING SUBTL
ON POLE
Allows the pole display to show a running
subtotal as items are entered.
To Next Page
Loading...
