Sam4s SER-7040 - KP Time Period

180
x
P-Mode Programming SER-7000 Program Manual
KP Time Period
Kitchen printer routing can be defined for four periods (see "Kitchen Printer Routing" on
page 57.) If you define different routing for different periods, you can set the start and end
times for the time periods here.
For example, a restaurant might require requisitions to be routed to separate hot and cold
sandwich preparation areas during lunch (11:00 AM to 2:00 PM) and at all other times, all
requisitions would be routed to the hot prep area. To meet this requirement, you could
program different kitchen printer routing for periods 1 and 2 under the Kitchen Printer
Routing program , then set the KP Time Periods as follows:
Period Start End Time
1 11:00 14:00
2 14:01 10:59
3 99:99 99:99
4 99:99 99:99
KP TIME PERIOD PROGRAMMING
PERIOD
START/END TIME
1 99:99 - 00:00
2 99:99 - 00:00
3 99:99 - 00:00
ESC Y/N ENTER PAGE UP/DN
npom
KP TIME PERIOD PROGRAMMING
PERIOD
START/END TIME
4 99:99 - 00:00

ESC Y/N ENTER PAGE UP/DN
npom
1. Select KP TIME
PERIOD from the
TIME ACTIVATED
FUNCTIONS MENU
to display the KP
TIME PERIOD
PROGRAMMING
screen.
2. The cursor displays in
the Start Time field
for Period 1, enter a
new time and press
ENTER.
3. Continue to set start
and end times for
each of 4 possible
periods. Enter a
start time of 99:99 to
inactivate a period.
4. Press ESC at any
point to exit the KP
TIME PERIOD
PROGRAMMING
screen.