Sam4s SER-7040 - Page 38

32
x
S-Mode Programming SER-7000 Program Manual
42
31
6. The display will monitor the memory clear process, which takes about 1 minute.
When complete, press any key.
x The display will prompt: “Enter Register Number (1-32)”. Type the
register number on the numeric keypad and press ENTER.
x The display will prompt: “Default Mem. Alloc.? [Y]”. Press the Y/N key to
toggle from Y (yes) to N (no), then press ENTER.
x The S-MODE PROGRAMMING MENU will display.