Sam4s SER-7040 - Page 49

SER-7000 Program Manual S-Mode Programming
x
43
WLU KEY RELOCATION PROGRAMMING
KEYBOARD LEVEL 1
x PRESS ANY KEY TO READ AND/OR
CHANGE CURRENT ASSIGNMENT
x PRESS ESC TO EXIT
KEY POSITION 13:
OLD=KEYCODE#013 ADD CHECK
NEW=WLU# 01 WLU#1
3. The old and new
assignments for the
key you have just
p
rogrammed display.
Continue to program
additional WLU key
locations by pressing
another key.
4. Press ESC to exit.
At the prompt:
EXIT? [Y] press
ENTER.
5. At the prompt:
SAVE KEY
RELOCATION? [Y]
press ENTER, or
press the Y/N key,
then press ENTER to
exit without saving
changes.