Sam4s SER-7040 - Page 51

SER-7000 Program Manual S-Mode Programming
x
45
FUNCTION KEY RELOCATION PROGRA
KEYBOARD LEVEL 1
x PRESS ANY KEY TO READ AND/OR
CHANGE CURRENT ASSIGNMENT
x PRESS ESC TO EXIT
KEY POSITION 167:
OLD=KEYCODE#021 CHECK
NEW=KEYCODE#026 CURR.CONV1
4. The old and new
assignments for the
key you have just
p
rogrammed display.
Continue to program
additional Function
key locations by
p
ressing another key.
5. Press ESC to exit.
At the prompt:
EXIT? [Y] press
ENTER.
6. At the prompt:
SAVE KEY
RELOCATION? [Y]
press ENTER, or
press the Y/N key,
then press ENTER to
exit without saving
changes.