Samsung Electronics 414
Key Options
■
Mode Select Switch Installation Instructions
Components
The Mode Select Switch is shipped with the following parts:
Mode Switch Selector,
Assembled
3-wire male connector
3-wire female
connector
M4X16 screws(2) Wiring harness
Installation
1. Disassemble the Mode Select Switch (Figure 1).
2. Insert a small screwdriver into one of the three square holes on the end of the 3-wire male connector and carefully.
depressing the tab (Figure 2).
3. Connect the correctly colored wire (refer to Figure 3) on the supplied wiring harness into the hole below the screwdriver.
Use caution to prevent damage to the tabs.
4. Repeat for the other two wires.
< Figure 1. Mode Select Switch assembly drawing > < Figure 2. Connecting the wiring harness to
the 3-wire male Connector. >
3-wire male
connector
Wiring harness
[WARNING]
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing.
Follow proper lockout/tagout procedures to ensure the power can-not be inadvertently energized.
Failure to disconnect power before servicing could result in death or serious injury.
8-5-4 Application of Mode select Switch (cont.)
8-5 Applications (cont.)
To Next Page
Loading...
