Samsung CLX-9250ND - Page 361

7. Trouble
s
● Code :
A1-2511
● Error message
A
ctuator Motor Fail
u
● Symptom / Cause :
1. Black motor is broken.
2. The relative connector is disconnected.
3. Deve joint board and main board are defective.
4. Even it was ready, it does not working.
5. After starting, it is not reached at ready state.
● Troubleshooting method :
1. Enter the diagnostic mode. Select the test routine.
Execute the black OPC BLDC motor test. If the m
o
2. If the problem persists, remove the rear cover.
3. Open the Main board plate.
4. Remove the black OPC BLDC motor and one of th
e
Install the removed black OPC BLDC motor to OP
C
Execute the black OPC BLDC motor test on diagn
o
5. If the motor doesn’t work, replace the black OPC
B
MCK
6. If the motor works, check the connection
7. Replace the Deve joint board or engine board.
● Replacement part
- JC31-00123A (MOTOR BLDC)
- JC92-02152A (DEVE-JOINT)
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
Service Manual
CLX-9250/9350 series
7-
2
- JC92-02239A : PB
A
-ENGINE (CLX-9250ND)
s
hooting
:
u
re #A1-2511: Please open/close door.
o
tor works, check the connection.
e
OPC BLDC motors.
C
BLDC position.
o
stic mode.
B
LDC motor.
Y
SAMSUNG ELECTRONICS
2
1