Samsung CLX-9250ND - Page 360

7. Trouble
s
● Code :
A1-2411
● Error message
A
ctuator Motor Fail
u
● Symptom / Cause :
1. Cyan motor is broken.
2. The relative connector is disconnected.
3. Deve joint board and main board are defective.
4. Even it was ready, it does not working.
5. After starting, it is not reached at ready state.
● Troubleshooting method :
1. Enter the diagnostic mode. Select the test routine.
Execute the Cyan OPC BLDC motor test. If the m
o
2. If the problem persists, remove the rear cover.
3. Open the Main board plate.
4. Remove the Cyan OPC BLDC motor and one of th
e
Install the removed Cyan OPC BLDC motor to OP
C
Execute the OPC BLDC motor test on diagnostic
m
5. If the motor doesn’t work, replace the Cyan OPC
B
MCK
6. If the motor works, check the connection
7. Replace the Deve joint board or engine board.
● Replacement part
- JC31-00123A (MOTOR BLDC)
- JC92-02152A (DEVE-JOINT)
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
Service Manual
CLX-9250/9350 series
7-
2
- JC92-02239A : PB
A
-ENGINE (CLX-9250ND)
s
hooting
:
u
re #A1-2411: Please open/close door.
o
tor works, check the connection.
e
OPC BLDC motors.
C
BLDC position.
m
ode.
B
LDC motor.
Y
SAMSUNG ELECTRONICS
2
0