Samsung CLX-9250ND - Page 404

7. Trouble
s
● Code :
C6-1412
● Error message
:
Fuser unit is not co
m
● Symptom / Cause :
1. The fuser unit could not detect the EEPROM.
2. EEPROM information is different from machine inf
o
3. Fuser unit is not compatible with this machine.
● Troubleshooting method :
1. Turn the machine off and turn it on again.
2. If the problem persists, check the following :
2.
If
the
problem
persists,
check
the
following
:
A. Turn the machine off.
B. Open the side-cover and remove the fuser unit.
C. Remove the support-lever belt on the front of the
f
D. Remove the frame-fuser front.
E. Check if the EEPROM connector is disconnected
.
F. Check if the EEPROM is broken or deformed.
G. Re-install the fuser unit.
H. Turn the machine on.
I. If the problem persists, replace the fuser unit.
3. Print the supply information report, if printing is pos
s
Check if EEPROM information is correct.
Check
if
EEPROM
information
is
correct.
● Replacement part
- JC91-00931A : FUSER (220V)
- JC91-00930A : FUSER (110V)
Service Manual
CLX-9250/9350 series
7-
6
s
hooting
:
m
patible. Check User's Guide.
o
rmation.
f
user unit.
.
s
ible.
SAMSUNG ELECTRONICS
6
4