Samsung CLX-9250ND - Page 415

7. Trouble
s
● Code :
H1-1411
H1-1417
H1-1418
● Error message :
Paper jam inside of
m
● S
y
mptom / Cause :
y
Paper transport jam (paper Input section)
- When you open and close the DCF take away door,
t
● Troubleshooting method :
1. Open the DCF take away door. Remove the jammed
1.
Open
the
DCF
take
away
door.
Remove
the
jammed
Close the DCF take away door. After warm up, if sa
2. Check if the wall connector of tray4 pick up unit is c
o
3. Enter the diagnostic mode, and check the feed sen
s
If the paper is contacting sensor and “Without paper
”
4. Check if the connector of the tray4 pick up unit on t
h
Reconnect it.
5. Replace the DCF (or HCF) controller.
●
Replacement part
●
Replacement
part
- JC93-00070A (FRAME MAIN-PICK UP)
- JC93-00174A (FRAME MAIN-PICK UP SECOND)
Service Manual
CLX-9250/9350 series
7-
7
s
hooting
m
achine.
t
he paper has jammed at the tray4 feed sensor.
d paper.
d
paper.
me jam occurs, check the following.
o
nnected properly. Reconnect the connector.
s
or test of the tray1 pick up unit.
”
message is displayed, replace the sensor.
h
e pick up drive unit is connected properly.
SAMSUNG ELECTRONICS
7
5