Samsung CLX-9250ND - Page 416

7. Trouble
s
● Code :
H1-1412
● Error message :
Paper jam in dual c
a
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper has not reached the tray4 feed sensor wit
h
● Troubleshooting method :
1. Open the side & take away door. Remove the jam
m
Close the Side door. After warm u
p,
if same
j
am oc
c
p, j
2. Install the Pick up (forward, retard )roller correctly.
3. If the pick up roller is worn out or contaminated, rep
4. Check if paper in the cassette are curled, replace th
5. Check if the wall connector of tray3 pick up unit is c
o
6. If the problem persists, remove the pick up unit and
A
. If the spring at the bottom of the pick up unit brea
k
If the assembly mold part with spring is broken, r
e
B. If the com
p
ression s
p
rin
g
of the
g
uide-forward
p
ic
k
ppgg
p
C. If the error message displays despite paper empt
y
interrupt. Reassemble the empty actuator or repla
c
In case that the actuator is broken, check the followin
g
1. Does the pick up (forward) roller rotate?
ACh kifth lth t fth ik di
A
.
Ch
ec
k
if
th
e c
l
u
t
c
h
connec
t
or o
f
th
e p
i
c
k
up
d
r
i
ve
u
B. Enter the diagnostic mode. Execute “clutch test” .
C. If the timing belt of the pick up drive unit breaks a
w
D. Check if the motor connector of the pick up drive
u
E. Enter the diagnostic mode. Execute “motor test” .
I
2. Re
p
lace the en
g
ine controller.
pg
● Replacement part
- JC93-00175A (FRAME MAIN-PICK UP RUBBER)
- JC93-00070A (FRAME MAIN-PICK UP)
- JC93-00174A (FRAME MAIN-PICK UP SECOND)
Service Manual
CLX-9250/9350 series
7-
7
s
hooting
a
pacity feeder.
h
in normal time after pick up.
m
ed paper.
c
urs
,
check the followin
g
.
,g
lace it.
e paper or stretch to remove curling.
o
nnected properly. Reconnect the connector.
check the following.
k
s away or is broken, replace the spring.
e
place it.
k
u
p
breaks awa
y,
reassemble or re
p
lace it.
py, p
y
in the cassette, check the empty actuator and photo
c
e the photo interrupter.
g
:
it i t d l R t it
u
n
it
i
s connec
t
e
d
proper
l
y.
R
econnec
t
it
.
If it is defective, replace it.
w
ay or is broken, replace it.
u
nit is connected properly. Reconnect it.
I
f it is defective, replace it.
SAMSUNG ELECTRONICS
7
6